« Flip This, Reverse That... | Main | Technology is Amazing... »

Wednesday, December 10, 2008

Use the Tab key to cycle through OSNAPS

Many times you will be using OSNAPS in a congested area of your drawing. So without having to go and turn off all of the OSNAP settings you don't want you can easily cycle through all of your OSNAPS that are turn on by moving your cursor to the general area and press the TAB key.

For example you have a bunch of lines, arcs and circles in an area of your drawing, you are trying to draw a line from the mdipoint of one of the arc entities. You would have the OSNAPs set like you normally would with End, Mid, Cen, Intersection etc.... Then start your line command, move your cursor to the general area and press TAB for each time you want to cycle to the next one.

Try it out.

TrackBack

TrackBack URL for this entry:
http://www.typepad.com/services/trackback/6a00d83482650853ef01053658bf35970c

Listed below are links to weblogs that reference Use the Tab key to cycle through OSNAPS:

Comments

The comments to this entry are closed.